Item Description

Abrasive blasting safety starts before the first blast, and this toolbox talk gives your crew a clear way to talk about it. Blasting with compressed air strips rust, paint and coatings from steel and concrete, but it also throws up thick clouds of dust and flying particles.

That dust can carry silica, lead or old paint particles too small to see. Breathing them can cause permanent lung damage that may not show up for years, and ricocheting particles injure eyes and skin. A dust mask and safety glasses are not enough.

In the Unsafe Dave story, Dave blasts a steel beam in a paper dust mask and glasses, with tape holding the deadman control open. Dust clouds his face and he starts coughing hard until Safety Sam shuts off the air and points him to the blast hood. Dave suits up, checks his hood and air supply, and finishes the job clean.

The talk gives your crew a short, discussion-ready conversation on:

Wearing a supplied-air blasting hood every time
Inspecting hoses, couplings and nozzles before blasting
Keeping the deadman control working and never taping it
Clearing the area, posting signs and containing dust
Cleaning up with a HEPA vacuum instead of dry sweeping

It also covers why nobody should ever point the nozzle at themselves or anyone else, and why blasters should tell the supervisor when conditions or air quality change.

It works well for safety managers, superintendents and foremen who run blasting in fabrication shops, on steel and concrete, or on coating removal jobs. Read it aloud at the start of a shift, ask the crew what they would have done differently from Dave, and put the matching poster where the blasting happens.

What this toolbox talk covers

  • Wear a supplied-air blasting hood every time.
  • Inspect hoses, couplings, and nozzles before blasting.
  • Keep the deadman control working and never tape it.
  • Clear the area and post signs before you start.
  • Never point the nozzle at yourself or anyone.
  • Contain dust; vacuum clean-up.

DID YOU KNOW?

Blasting dust can carry silica, lead, or old paint particles that are too small to see. Breathing them can cause permanent lung damage that may not show up for years. Blasters need a proper supplied-air respirator, even on short jobs, and should check it before every shift.

Common questions

Why is abrasive blasting dust dangerous?

The dust can carry silica, lead or old paint particles that are too small to see. Breathing them can cause permanent lung damage that may not show up for years.

What respirator should be used for abrasive blasting?

Blasters should use an approved abrasive-blasting respirator or hood supplied with clean, breathable air. Dust masks and safety glasses are not enough, and the hood and air supply should be checked before every shift.

What is a deadman control on a blast nozzle?

It is a control that shuts off the flow of abrasive when the operator lets go. It must never be taped or tied down, so it can stop the blast if something goes wrong.

Includes the print-ready toolbox talk and a matching safety poster, in English and Spanish, for daily jobsite safety meetings.

Safety First View profile

A five-minute toolbox talk can prevent a five-week recovery—take the time or take the consequences!

Included Files:
- Toolbox Talk (PDF)
- English + Spanish
- Print-Ready Safety Poster
- Sign-in/Attendance Sheet
- Facilitator Tips

Close

Send listing report

highlight_off

You already reported this listing

The report is private and won't be shared with the owner

rotate_right

Ver esta charla de seguridad en español

Close
rotate_right
Close

Send Message

image
Close

My favorites

image
Close

Application Form

image
Notifications visibility rotate_right Clear all Close close
image
image
arrow_left
arrow_right